光纤基底TiNi形状记忆合金薄膜制备工艺

将TiNi基记忆合金薄膜与光纤相结合可制成智能化、集成化且成本经济的微机电系统和微传感器件.本文采用磁控溅射法在二氧化硅光纤基底上制备TiNi记忆合金薄膜,系统讨论了溅射工艺参数以及后续退火处理对薄膜质量的影响.采用自研制光纤镀膜掩膜装置在直径为125μm的光纤圆周表面上形成均匀薄膜.实验表明:在靶基距、背底真空度、Ar气流量和溅射时间一定的条件下,溅射功率存在最佳值;溅射压强较大时,薄膜沉积速率较低,但薄膜表面粗糙度较小.进行退火处理后,薄膜形成较良好的晶体结构,Ti_49.09Ni_50.91薄膜中马氏体B19′相和奥氏体B2相共存,但以B19′为主.根据本文研究结果,在玻璃光纤基底上制备高质量的TiNi基记忆合金薄膜是可实现的,本工作为下一步研制微机电系统和微型传感器做了基础准备.     

Ultrastretchable and conductive core/sheath hydrogel fibers with multifunctionality

Conductive hydrogels with ionic compounds possess great potential for the development of soft smart devices. A dielectric scarfskin is typically required for these devices to prevent short circuiting, leading to devices with lower stretchability than the hydrogel. Henceforth, commonly used dielectric materials, such as PDMS and Ecoflex, cannot be largely stretched. Hydrogel devices with ultrastretchability are required to accommodate hostile application environments. Herein, we propose a hydrogel fiber coated with a dielectric layer that can be stretched to over 2000% of its initial length. The fiber remains conductive when stretched to ~1300%. In addition, the core/sheath hydrogel fiber can be endowed with a variety of functional properties, such as electroluminescence (EL), photoluminescence (PL), and magnetic‐responsiveness, demonstrating scalability of the resultant fiber. The present work can pave the way for numerous next‐generation soft devices, such as smart textiles and wearable electronics. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 272–280     

Tunable and highly sensitive temperature sensor based on graphene photonic crystal fiber

Optical fiber temperature sensors have been widely employed in enormous areas ranging from electric power industry, medical treatment, ocean dynamics to aerospace. Recently, graphene optical fiber temperature sensors attract tremendous attention for their merits of simple structure and direct power detecting ability. However, these sensors based on transfer techniques still have limitations in the relatively low sensitivity or distortion of the transmission characteristics, due to the unsuitable Fermi level of graphene and the destruction of fiber structure, respectively. Here, we propose a tunable and highly sensitive temperature sensor based on graphene photonic crystal fiber (Gr-PCF) with the non-destructive integration of graphene into the holes of PCF. This hybrid structure promises the intact fiber structure and transmission mode, which efficiently enhances the temperature detection ability of graphene. From our simulation, we find that the temperature sensitivity can be electrically tuned over four orders of magnitude and achieve up to ～ 3.34×10^-3 dB/(cm·℃) when the graphene Fermi level is ～ 35 meV higher than half the incident photon energy. Additionally, this sensitivity can be further improved by ～ 10 times through optimizing the PCF structure (such as the fiber hole diameter) to enhance the light-matter interaction. Our results provide a new way for the design of the highly sensitive temperature sensors and broaden applications in all-fiber optoelectronic devices.     

Comparative analysis of the main active components and hypoglycemic effects after the compatibility of Scutellariae Radix and Coptidis Rhizoma

In this study, a rapid and highly sensitive ultra high performance liquid chromatography with triple quadrupole mass spectrometry method with the mobile phase of acetonitrile and 0.1% aqueous formic acid was established and successfully applied to comparatively analyze main active components after their compatibility. Besides, the effects of Scutellariae Radix, Coptidis Rhizoma and combined extracts on type 2 diabetic rats induced by high‐fat diet along with low dose of streptozocin were investigated. Under the optimized chromatographic conditions, good separation of seven target components was achieved within 12 min. All calibration curves exhibited good linearity (R² ≥ 0.999). The relative standard deviation of precision, repeatability and stability varied from 0.69 to 2.23, 0.98 to 2.56, and 0.92 to 2.57%, respectively. The recovery ranged from 91.11 to 105.35%. The contents of seven active components were notably reduced after compatibility; however, the hypoglycemic effect of combined extracts was stronger than single drug by decreasing the activities of fructose‐1,6‐bisphosphatase, glucose 6‐phosphatase, phosphoenolpyruvate carboxykinase and increasing the activities of glucokinase, phosphofructokinase, pyruvate kinase. Accordingly, the established analytical method was accurate and sensitive enough for quantitative evaluation of seven investigated compounds. Moreover, the combined extract had definite effects on type 2 diabetes through multiple components against multiple targets.     

级联光栅结合Sagnac环的可调谐光纤激光器

提出并验证了一种单-双波长可调谐掺铒光纤激光器。利用级联光纤布拉格光栅(Cascaded Fiber Bragg gratings,Cascaded FBGs)结合Sagnac环结构所产生的复合滤波效应,实现较高精细度滤波,并通过调节环内偏振控制器(Polarization Controller,PC),引入双折射效应,得到波长可调谐的光纤激光器。基于耦合模理论并使用传输矩阵法对该结构的传输特性进行了分析,在此基础上搭建实验系统,验证了理论分析的正确性。实验结果表明:通过调节PC,激光器输出激光的波长范围约为1 555.644～1 556.112 nm,双波长间隔的可调范围约为0.108～0.452 nm,单-双波长的边模抑制比(SMSR)均高于40 dB;在稳定性测试中,输出单-双波长激光的波长最大漂移量小于0.008 nm。该方法具有结构简单、调谐方便、易于实现且精细度较高的优点,可应用于密集波分复用及全光通信系统等领域。     

Optomechanical-organized multipulse dynamics in ultrafast fiber laser

A novel organized multipulse pattern and its birth dynamics under strong optomechanical effect in microfiber-assisted ultrafast fiber laser are investigated in this work. The background pulses are observed to obviously exhibit selectively amplifying self-organized process of evolving into quasi-stable equidistant clusters. The radio frequency spectrum of the multipulse pattern displays a harmonic mode-locking-like behavior with a repetition rate of 2.0138 GHz, corresponding to the frequency of torsional-radial (TR_2m) acoustic mode in microfiber. The results show the evidence of optomechanical effect in dominating the birth dynamics and pattern of multipulse.     

油-气-水三相流超声传感器持气率测量*

为探索油-气-水三相流持气率测量难题,该文开展了脉冲透射式超声传感器持气率测量动态实验研究。首先,利用超声传感器与光纤传感器组合,测取了油-气-水三相流中段塞流、混状流、泡状流的响应信号;其次,提取了超声脉冲信号的最大值序列来反映不同流型时超声传感器响应特性,同时,借助双头光纤传感器与相关测速法,计算得到了流体中气泡弦长序列;最后,结合流型与泡径信息,利用超声传感器测量了不同流型下持气率,并分析了不同流型持气率预测的误差来源,为其他油-气-水三相流持气率测量传感器设计提供了借鉴。     

Enhanced mechanical properties of unidirectional basalt fiber/epoxy composites using silane-modified Na+-montmorillonite nanoclay

This study explores the effects of 3-glycidoxypropyltrimethoxysilane (3-GPTS) modified Na-montmorillonite (Na-Mt) nanoclay addition on mechanical response of unidirectional basalt fiber (UD-BF)/epoxy composite laminates under tensile, flexural and compressive loadings. Fourier transform infrared (FT-IR), X-ray diffraction (XRD) and simultaneous thermal analysis (STA) data confirmed the reaction mechanism between the silane compound and Mt. It was demonstrated that addition of 5 wt % 3-GPTS/Mt resulted in 28%, 11% and 35% increase in flexural, tensile and compressive strengths. Scanning electron microscopy (SEM) clarified the improvement in the adhesion between the basalt fibers and matrix in the case of Mt-enhanced epoxy specimens. Also, a theoretical route based on a Euler-Bernoulli beam-based approach was employed to estimate the compressive properties of the composites. The results demonstrated good agreement between theoretical and experimental approaches. Totally, the results of the study show that matrix modification is an effective strategy to improve the mechanical behavior of fibrous composites.